Skip to content

Cart

Your cart is empty

Join the Gunstreet Mailing List

Sign up to the Gunstreet mailing list and become an expert in the circuits and pickups that make your instrument sing.

FREE SHIPPING ON ALL DOMESTIC ORDERS $75+

How to install

STARTING WITH THE BRIDGE PICKUP

Solder Your Bridge Pickup's "Hot" also known as "+" on the diagram to the Left open Lug on the Bridge Volume pot

 

Next, Solder the Bridge Pickup's "Ground" also known as "-" on the diagram to the casing of the Bridge Volume pot. Make sure the Braided part of the wire is far away from hot joint you previously soldered.Not doing so can cause you to kill the signal

Repeat these steps but on the Neck volume with the Neck Pickup

Finishing the Installation

Solder the Tailpeice ground wire to the casing on any pot. In this example it was the Neck Tone as it was the closest to the wire. If you have shielded your Cavity. Solder a jumper wire from the shielding to the wiring harness itself. Soldering it to a pot casing like how we did it with the tailpeice ground.

Pro Tip

If you are using braided wire pickups, make sure the wires are away from the switch as the braided part will ground your whole signal if it touches a hot path on the switch

And thats it!

Test the controls before restringing the guitar by lightly taping the pickups with a metal object. If you have any questions of need any help Troubleshooting Click here