Skip to content

Cart

Your cart is empty

Join the Gunstreet Mailing List

Sign up to the Gunstreet mailing list and become an expert in the circuits and pickups that make your instrument sing.

FREE SHIPPING ON ALL DOMESTIC ORDERS $75+

How to install

This instruction works for a Modern or Volume Bleed kit

STARTING WITH THE SWITCH WIRES

Before we start. Lets talk about the switch color code.

  • Red/N = Rhythm/Neck
  • Yellow/O = Outjack Jack
  • Blue/B = Bridge
  • Black/G = Ground

Don't install the pots in the guitar yet, instead fish the switch wires through the cavity.

Solder the red Neck wire to the Top right Lug

Next, solder the Black Cloth wire to the Middle lug next to your neck joint

Solder the Blue Bridge wire to the Bottom Left Lug

Solder the yellow Output wire to the two Middle lugs on the opposite side of the switch.

Install the switch into the cavity. Just make sure the cavity walls or the braided wire is not touching the switch as this can cause a "short" in your switch.

Starting with the Bridge pickup

Solder your pickups "Hot/+" to the far left lug on the Volume Pot.

 

Solder the "Series Link/S" to the push pull hole labelled C2

Solder the "Ground/-" to the casing on the Volume Pot. If using a braided wire style pickup make sure the braided part of the wire is away from the hot joint you previously soldered

Repeat these steps with the Neck Pickup on the Neck Volume

Finishing the installation

Solder the wire coming from your guitars Tailpeice to the casing of any pot. On this example the Neck volume was the easiest.

And thats it!

Test the controls before restringing the guitar by lightly taping the pickups with a Metal object.