FREE SHIPPING ON ALL DOMESTIC ORDERS $75+
How to install
STARTING WITH THE BRIDGE PICKUP
Solder Your Bridge Pickup's "Hot" also known as "+" on the diagram to the Left open Lug on the Bridge Volume pot
Next, Solder the Bridge Pickup's "Ground" also known as "-" on the diagram to the casing of the Bridge Volume pot. Make sure the Braided part of the wire is far away from hot joint you previously soldered. Not doing so can cause you to kill the signal
Repeat these steps but on the Neck volume with the Neck Pickup
Finishing the Installation
Solder the Tailpeice ground wire to the casing on any pot. In this example it was the Neck Tone as it was the closest to the wire. If you have shielded your Cavity. Solder a jumper wire from the shielding to the wiring harness itself. Soldering it to a pot casing like how we did it with the tailpeice ground.
Pro Tip
If you are using braided wire pickups, make sure the wires are away from the switch as the braided part will kill your whole signal if it touches a hot path on the switch
And thats it!
Test the controls before restringing the guitar by lightly taping the pickups with a metal object. If you have any questions of need any help Troubleshooting Click here