Skip to content

Cart

Your cart is empty

FREE SHIPPING ON ALL DOMESTIC ORDERS $75+

How to install

This instruction works for a 50s, Modern, or Volume Bleed wiring kit

Starting with the Neck pickup

Solder your Neck pickups "Hot/+" to the far right lug on the right angle toggle switch.

 

Solder your Bridge pickups "Hot/+" to the far Left lug on the right angle toggle switch.

Finishing the pickup installation

Combine both "Grounds/-" from the Neck and Bridge Pickups, and solder them to the Top middle lug. Just make sure these wires are only touching that lug and not the switch itself, or the previuos joints we soldered as this could ground out your whole signal.

Finishing the pickup installation

Solder the wire(S) coming from your guitars tailpeice to the casing of any pot. On this example the tone pot was the easiest.

And thats it!

Test the controls before restringing the guitar by lightly taping the pickups with a Metal object.