FREE SHIPPING ON ALL DOMESTIC ORDERS $75+
How to install
In these Instruction photos we will be using Seymour Duncan's Color Code.
- Black = Hot "+"
- Red/White Soldered Together = Series Link "S"
- Green/Bare soldered together = Ground "-"
Check with your pickups manufacture to learn what color code they use.
STARTING WITH THE BRIDGE PICKUP
Solder Your Bridge Pickup's "Hot" also known as "+" on the diagram to the Left open Lug on the Bridge Volumes potentiemeter
Next, Solder the Bridge Pickup's "Series Link" also known as "S" on the diagram to the switch hole labelled "C2" of the Bridge Volume pot
Finishing the Bridge pickup Installation
Solder Your Bridge Pickup's "ground" and "Bare Chassis ground wire" also known as "-" on the diagram to the Metal casing on the Bridge Volumes potentiemeter
Repeat these steps but on the Neck Volume with the Neck Pickup
Finishing the Installation
Solder the Tailpeice ground wire to the casing on any pot. In this example it was the Neck tone as it was the closest to the wire. If you have Shielded your cavity. Add a jumper wire from the Shielding itself to the wiring harness. Solder the wire to a pot casing just like how we did it with the tailpeice ground wire