Thank you for choosing Gunstreet. below is the instructions for a 50s Wiring to be installed in your Flying V.
Most Common Pickup Wires
Stage One
Neck Volume Install
Solder the Hot Pickup wire to the First Lug on the potentiometer. See diagram on the left. If not sure which wire is hot please refer to your pickups manufacturers instructions
Next, Solder the pickups Ground to the casing of the Volume Pot.
Repeat these steps for the Bridge Volume
Grounding the Harness
Solder the Ground Wire coming from your guitar bridge to the Casing of the any Pot
Output Jack Assembly
Solder the Black Wire coming from your guitars tone control to the ground of the output jack label B on the Diagram.
Solder the White Wire to the Hot on the output Labeled A on the diagram.